Welcome to our Knowledge Base

Which connections are needed?

Two power connections (230V) as well as an access to the Internet (network cable or a network connection) are required. If there is no network connection at the installation site, but only a power connection, you can use a powerline adapter that sends the network signal via the power line. The devices of the SF-300 series (from BJ 2016) are equipped with an integrated WLAN antenna. For the SF-100 series an optional WLAN stick, available at Solarfox, can be used. Your own Wi-Fi USB adapters are not supported. If there is no internet connection on site, the display can be connected to a mobile radio router.


Further information about the installation can be found in our installation instructions. Category: Service -> Tenders and Planning.

PV display with interfaces for numerous monitoring systems

Was this article helpful?
0 out of 5 stars
5 Stars 0%
4 Stars 0%
3 Stars 0%
2 Stars 0%
1 Stars 0%
Please Share Your Feedback
How Can We Improve This Article?